DURKOPP ADLER 513 - Page 49

Programming
Operating Instructions 513/533 - 01.0 - 09/2023 47
Fig. 30: Registering a new seam pattern (3)
14. The increment for X-scaling can be set to 1 %. Set the value
to 50 % using the buttons.
15. Press the buttons.
 The Y-scaling value is displayed as 100 %.
Fig. 31: Registering a new seam pattern (4)
16. The increment for Y-scaling can be set to 1 %. Set the value
to 80 % using the buttons.
17. Press the buttons.
 The value currently set for the speed is displayed.
Fig. 32: Registering a new seam pattern (5)