Dynamic RHINO2 User Manual

Chapter 6: Appendices
121
can no longer be guaranteed and Dynamic Controls recommends the product be replaced
for safety reasons. Dynamic Controls accepts no responsibility/liability for product failure if the
product is continued to be used after the expected service life period has expired.
6.5 Maintenance
The following instructions must be passed on to the operator before use of the product.
1. Keep all DYNAMIC electronic components free of dust, dirt and liquids. To clean the
product, use a cloth dampened with warm soapy water. Do not use chemicals, solvents
or abrasive cleaners, as this may cause damage to the product.
2. Monthly check all vehicle components for loose, damaged or corroded components,
such as connectors, terminals, or cables. Restrain all cables to protect them from
damage. Replace damaged components.
3. Every 6 months, test all switchable functions on the DYNAMIC electronics system to ensure
they function correctly.
4. There are no user-serviceable parts in any DYNAMIC electronic component. Do not
attempt to open any case or undertake any repairs, else warranty will be voided and the
safety of the system may be compromised.
5. Where any doubt exists, consult your nearest service centre or agent.
Warning:
It is the responsibility of the end-user to maintain the unit in a state of good repair
at all times. If any component is damaged in any way, or if internal damage
may have occurred (for example by being dropped), have it checked by
qualified personnel before operating.
6.6 Warranty
All equipment supplied by Dynamic Controls is warranted by the company to be free from
faulty workmanship or materials. If any defect is found within the warranty period, the
company will repair, or at its discretion replace, the equipment without charge for materials
or labour.
This warranty is subject to the provisions that the equipment:
has been correctly installed.
has been thoroughly checked upon completion of installation, and all programmable
options correctly adjusted for safe operation prior to use.
has been used solely in accordance with this manual and all other manuals of the
DYNAMIC electronic components that are used on the scooter.
has been properly connected to a suitable power supply in accordance with this manual.
has not been subjected to misuse or accident, or been modified or repaired by any
unauthorised personnel.
has been used solely for the driving of electrically powered mobility scooters in
accordance with the intended use and the recommendations of the scooter
manufacturer.
has not been connected to third party devices without the specific approval of Dynamic
Controls.

Dynamic RHINO2 Specifications

General

Brand	Dynamic
Model	RHINO2
Category	Controller
Language	English