Dynamic RHINO2 User Manual

Chapter 4: Programming the Rhino2
63
4.4 Parameter Descriptions
Warning:
Any given starting point settings in this section must be used as a guideline only.
It is the responsibility of the scooter manufacturer to make sure that the program is
safe and suitable for a particular scooter configuration.
It is the responsibility of the dealer or therapist to check and make sure that the
settings of a scooter for a particular user are safe and appropriate for that user.
4.4.1 User Personalisation
4.4.1.1 Sleep Timer
Parameter
Possible Values
Default
HHP
Lite
Std
Adv
Sleep Timer
0 - 30min
30min


The RHINO2 automatically "goes to sleep" if the throttle has been in the Neutral position for
Sleep Timer minutes. When the RHINO2 sleeps, it is partially turned off to reduce energy
consumption and to make sure that the scooter does not move if the user accidentally
moves the throttle. In Sleep Mode, the scooter does not respond to commands.
To wake up the RHINO2, take the action that is selected with Wakeup Style.
If Wakeup Style is set to 'Key + Throttle', the Status Light gives a short flash every 5 seconds
during sleep mode.
To disable Sleep Mode, set Sleep Timer to zero.
4.4.1.2 Wakeup Style
Parameter
Possible Values
Default
HHP
Lite
Std
Adv
Wakeup Style
Key + Throttle
Key Only
Key Only

Defines how the controller will wake up from sleep.
Key Only - Only the key switch wakes up the controller (by turning the key off and then
on again).
Key + Throttle - The key switch as well as any throttle movement wakes up the controller.
Note:
If the value of Sleep Timer is zero, the value of Wakeup Style
is ignored.

Dynamic RHINO2 Specifications

General

Brand	Dynamic
Model	RHINO2
Category	Controller
Language	English