Dynamic RHINO2

Chapter 4: Programming the Rhino2
53
4.1.1.2 Non-profiled
The parameters that are not in the Drive Profiles can be adjusted in the Non-Profiled menu.
1. In the Main Menu screen, press PROG to enter the Programming Menu.
2. To select Non-Profiled, press NEXT twice and then press EDIT.
3. Press NEXT until the desired parameter is shown.
4. Press UP or DOWN to adjust the parameter to the desired value. Please note that each
change is effective immediately, there is no option to cancel a change. To undo a
change, manually set the parameter back to its original setting with UP or DOWN.
5. Press EXIT twice to return to the Main Menu.
In the Non-Profiled Menu, the following parameters can be adjusted:
Parameter
Section
Sleep Timer
4.4.1.1
Enable Beeper
4.4.1.4
Swap Throttle Direction
4.4.1.3
Battery Capacity
Higher settings make the
battery gauge react slower.
Service Scheduler (Service Period)
4.4.8.1
Beep on Fault (Flash Code Beeper)
4.4.1.5
Beep on Sleep (Sleep Beeper)
4.4.1.6
Reversing Beeper
4.4.1.7
Motion Beeper
4.4.1.7
V i e w / E d i t
Non- P r o f i l e d
EXIT NEXT EDIT
Main
Menu
Next Option
(Calibrate, Prof 1/2)
Choose this
Option
Non- P r o f i l e d
Sleep Timer
1 5 m i n
EXIT NEXT DOWN UP
Adjust this
Parameter
Back to
Prog Menu
Non-Profiled Menu
Programming Menu
Next
Parameter