Chapter 4: Programming the Rhino2
4.1.1 Programming menu
The programming menu gives access to
The speed and acceleration settings of Drive Profile 1 and Drive Profile 2
Other (non-profiled) settings such as left or right handed throttle, sleep timer, beeper
settings and the service scheduler
Throttle calibration
4.1.1.1 Profile 1/2
The RHINO2 has 2 Drive Profiles that are typically used for:
Drive Profile 1 - Normal Drive
Drive Profile 2 - A 'Slow Speed' mode for indoor use, that the user can select with a 'Slow' switch
Normally Drive Profile 1 is always selected. Drive Profile 2 is only used when
Pin [X] Function (4.4.9.1) is set to 'Profile 2' and the associated input pin is activated.
1. In the Main Menu screen, press PROG to enter the Programming Menu.
2. To select Drive Profile 1, press EDIT. To select Drive Profile 2, press NEXT and then press EDIT.
3. Press NEXT until the desired parameter is shown.
4. Press UP or DOWN to adjust the parameter to the desired value. Please note that each
change is effective immediately, there is no option to cancel a change. To undo a
change, manually set the parameter back to its original setting with UP or DOWN.
5. Press EXIT twice to return to the Main Menu.
For each drive profile, the following parameters can be adjusted:
Dynamic 2GS VX.XX
S y s t e m O K
P R O G D I A G T E C H
V i e w / E d i t
P r o f i l e 1
EXIT NEXT EDIT
Go to the
Programming Menu
Menu
Next Option (Prof 2,
Non-prof, Calibrate)
Option
V i e w / E d i t
P r o f i l e 1
EXIT NEXT EDIT
Menu
Next Option (Prof 2,
Non-prof, Calibrate)
Option
P r o f i l e 1
Max Forward Speed
100%
EXIT NEXT DOWN UP
Parameter
To Next Page
Loading...
Need help?
General
