Dynamic RHINO2 User Manual

Chapter 4: Programming the Rhino2
65
4.4.1.6 Sleep Beeper
Parameter
Possible Values
Default
HHP
Lite
Std
Adv
Sleep Beeper
No / Yes
Yes




This parameter is only used when Enable Beeper has the value 'Yes'.
Yes - When the controller goes to sleep, the buzzer beeps for one second.
No - When the controller goes to sleep, the buzzer does not beep.
4.4.1.7 Motion Beeper
Parameter
Possible Values
Default
HHP
Lite
Std
Adv
Motion Beeper
Wizard
None
Reverse
Forward/Reverse
HHP
Yes
No
Wizard
Reverse
HHP
No











This parameter is only used when Enable Beeper has the value 'Yes'.
None - The scooter does not beep when it is moving
Reverse - The scooter beeps only when it is moving in the reverse direction
Forward/Reverse - The scooter beeps when it is moving in any direction
4.4.1.8 Reversing Beeper
Parameter
Possible Values
Default
HHP
Lite
Std
Adv
Reversing Beeper
Yes
No
No


Note that the Reversing Beeper parameter does not exist in the Wizard since the Motion
Beeper parameter can be used to switch on the beeper for reversing.
When using the HHP to program, use both the Motion Beeper and the Reversing Beeper
parameters, as set out in the table below.
Motion Beeper
Reversing Beeper
Wizard Equivalent
No
Yes
Reverse
Yes
Yes
None
No
No
None
Yes
No
Forward/Reverse
4.4.1.9 Beeper Timing
Parameter
Possible Values
Default
HHP
Lite
Std
Adv
Beeper On Time
100 – 1500ms
300ms



Beeper Off Time
0 – 1500ms
700ms



These parameters are only used when Enable Beeper has the value 'Yes'.

Dynamic RHINO2 Specifications

General

Brand	Dynamic
Model	RHINO2
Category	Controller
Language	English