Eaton PowerXL Series - Page 234

210
Appendix A—Parameter ID list
POWERXL SERIES VFD MN040010EN—June 2018 www.eaton.com
Menu Item
No.
Modbus
Register
PROFIBUS
Parameter Description
Data
Type
Length
(in Bytes)
Display
FormatPNU
PNU
SubIndex
P4.4.1 2122 NA NA Currency BYTE 1 x0
P4.4.2 2123 NA NA Energy Cost INTEGER 2 x100
P4.4.3 2124 NA NA Data Type BYTE 1 x0
P4.4.4 2125 NA NA Energy Savings Reset BYTE 1 x0
P5.1.1 287 255 0 Motor Control Mode BY TE 1 x0
P5.1.2 107 281 0 Current Limit INTEGER 2 x10
P5.1.3 109 60 0 V/Hz Optimization BOOLEAN 1 x0
P5.1.4 108 61 0 V/Hz Ratio BYTE 1 x0
P5.1.5 289 23 0 Field Weakening Point INTEGER 2 x100
P5.1.6 290 24 0 Voltage at FWP INTEGER 2 x100
P5.1.7 291 23 1 V/Hz Mid Frequency INTEGER 2 x100
P5.1.8 292 24 1 V/Hz Mid Voltage INTEGER 2 x100
P5.1.9 293 27 0 Zero Frequency Voltage INTEGER 2 x100
P5.1.10 2522 NA NA Switching Frequency INTEGER 2 x10
P5.1.11 1665 341 0 Sine Filter Enable BY TE 1 x0
P5.1.12 294 626 3 OverVoltage Control BY TE 1 x0
P5.1.13 298 2901 0 Load Drooping INTEGER 2 x100
P5.1.14 1630 2902 0 Droop Control Filter Time Constant INTEGER 2 x0
P5.2.1 577 210 1 Motor Nom Current 2 INTEGER 2 x10
P5.2.2 578 217 1 Motor Nom Speed 2 INTEGER 2 x0
P5.2.3 579 215 1 Motor PF 2 INTEGER 2 x100
P5.2.4 580 211 1 Motor Nom Volt 2 INTEGER 2 x0
P5.2.5 581 216 1 Motor Nom Freq 2 INTEGER 2 x100
P6.1.1 308 840 9040 Output Phase Fault BYTE 1 x0
P6.1.2 309 840 9008 Ground Fault BYTE 1 x0
P6.1.3 2158 NA NA Ground Fault Limit BYTE 1 x0
P6.1.4 310 840 17168 Motor Thermal Protection BYTE 1 x0
P6.1.5 311 1012 0 Motor Thermal F0 Current INTEGER 2 x10
P6.1.6 312 1011 0 Motor Thermal Time BYTE 1 x0
P6.1.7 313 840 28963 Stall Protection BYTE 1 x0
P6.1.8 314 1010 0 Stall Current Limit INTEGER 2 x10
P6.1.9 315 1010 1 Stall Time Limit INTEGER 2 x10
P6.1.10 316 1010 2 Stall Frequency Limit INTEGER 2 x100
P6.1.11 317 840 28979 Underload Protection BY TE 1 x0
P6.1.12 318 1013 0 Underload Fnom Torque INTEGER 2 x10
P6.1.13 319 1013 1 Underload F0 Torque INTEGER 2 x10
P6.1.14 320 1011 1 Underload Time Limit INTEGER 2 x100
P6.1.15 333 840 28978 Thermistor Fault Response BYTE 1 x0
P6.1.16 337 8 40 29536 PT100 Fault Response BY TE 1 x0
P6.1.17 2159 NA NA Preheat Mode BY TE 1 x0
P6.1.18 2160 NA NA Preheat Control Source BY TE 1 x0
P6.1.19 2161 NA NA Preheat Enter Temp INTEGER 2 x10
P6.1.20 2162 NA NA Preheat Quit Temp INTEGER 2 x10
P6.1.21 2163 NA NA Preheat Output Volt BYTE 1 x0
P6.2.1 750 861 0 Line Start Lockout BYTE 1 x0
P6.2.2 2483 NA NA Fault Reset Start BYTE 1 x0
P6.2.3 306 840 29520 4mA Input Fault BYTE 1 x0
P6.2.4 331 1 7 4mA Fault Frequency INTEGER 2 x100
P6.2.5 307 840 36864 External Fault BYTE 1 x0
P6.2.6 332 840 12592 Input Phase Fault BYTE 1 x0
P6.2.7 330 840 12576 Uvolt Fault Response BYTE 1 x0
Table 206. DH1 Parameter ID list, continued