Eldes ESIM384 - Page 13

13
13
EN
ESIM384 Installation and Conguration Manual v1.1
IP Server 1... 3 – encryption key 0000

Communication - primary IP Server 1 (GPRS)
  
Communication – backup 1... 5 N/A
  
Retry after delay N/A

Delay after last communication attempt 1200 seconds
  
SIA IP protocol settings - encryption Disabled

SIA IP protocol settings – encryption key 0000

SIA IP protocol settings – account prex N/A

SIA IP protocol settings – receiver number N/A

SIA IP protocol settings – use time stamp Enabled

SIA IP protocol settings – Contact ID ping Disabled

SIA IP protocol settings – data message Event: 1602, partition: 01, user/zone: 000

Data Messages
Burglary alarm/restore – code 130

Burglary alarm/restore – status Enabled
  
Main power loss/restore – code 301

Main power loss/restore – status Enabled
  
Armed/disarmed by user – code 401

Armed/disarmed by user – status Enabled
  
Test event – code 602

Test event – status Enabled
  
Battery failed – code 309

Battery failed – status Enabled
  
Battery dead or missing – code 311

Battery dead or missing – status Enabled
  
Tamper alarm/restore – code 144

Tamper alarm/restore – status Enabled
  
Instant Silent zone alarm/restore – code 146

Instant Silent zone alarm/restore – status Enabled
  
Kronos ping – code 602

Kronos ping – status Enabled
  
System started – code 900

System started – status Enabled
  
24H zone alarm/restore – code 133

24H zone alarm/restore – status Enabled
  
Fire zone alarm/restore – code 110

Fire zone alarm/restore – status Enabled
  
Low battery – code 302

Low battery – status Enabled
  
Temperature exceeded – code 158

Temperature exceeded – status Enabled
  
Temperature fallen – code 159

Temperature fallen – status Enabled
  
Wireless signal loss/restore – code 381

Wireless signal loss/restore – status Enabled
  
Disarmed by user (duress code) – code 121

Disarmed by user (duress code) – status Enabled
  
SGS code entered – code 463

SGS code entered – status Enabled
  
Armed by user (partial arm) – code 456

Armed by user (partial arm) – status Enabled
  
RF jammer detected - code 344

RF jammer detected - status Enabled
  
Siren fail/restore – code 321

Siren fail/restore – status Disabled
  
Date/time not set – code 626

Date/time not set – status Enabled
  
GSM connection failed – code 358

GSM connection failed – status Enabled
  
GSM/GPRS antenna fail/restore – code 359

GSM/GPRS antenna fail/restore – status Disabled
  
System shutdown – code 414

System shutdown – status Enabled
  
Communication bus fail/restore – code 330
