Eldes ESIM384 - Page 151

151
151
EN
ESIM384 Installation and Conguration Manual v1.1
Set attempts
EKB2
Menu path:
Server 1: OK → iiii → OK → MS SETTINGS → OK → IP SETTINGS → OK → SERVER IP → OK → IP
ATTEMPTS → OK → att → OK
Server 2: ... → SERVER2 IP → OK → IP ATTEMPTS → OK → att → OK
Server 3: ... → SERVER3 IP → OK → IP ATTEMPTS → OK → att → OK
Value: iiii – 4-digit installer code; att – number of attempts, range – [1... 255].
EKB3/
EKB3W/
EWKB4
Enter parameter 68 and number of attempts/parameter 96, parameter number
and number of attempts:
Server 1: 68 att #
Server 2: 96 08 att #
Server 3: 96 09 att #
Value: att – number of attempts, range – [01... 255].
Example: 6809#
ELDES
Cong-
uration
software
This operation may be carried out from the PC using the ELDES Conguration software.
To report the online status, the system periodically transmits (by default – every 180 seconds) Test Event data message (ping) to the mon-
itoring station via GPRS network or Ethernet.
Set test period
EKB2
Menu path:
Server 1: OK → iiii → OK → MS SETTINGS → OK → IP SETTINGS → OK → SERVER IP → OK → TEST
PERIOD → OK → tteessttpp → OK
Server 2: ... → SERVER2 IP → OK → TEST PERIOD → OK → tteessttpp → OK
Server 3: ... → SERVER3 IP → OK → TEST PERIOD → OK → tteessttpp → OK
Value: iiii – 4-digit installer code; tteessttpp – test period, range – [0... 65535] seconds.
EKB3/
EKB3W/
EWKB4
Enter parameter 46 and number of attempts/parameter 96, parameter number
and number of attempts:
Server 1: 46 tteessttpp #
Server 2: 96 10 tteessttpp #
Server 3: 96 11 tteessttpp #
Value: tteessttpp – test period, range – [0... 65535] seconds.
Example: 46120#
ELDES
Cong-
uration
soft-
ware
This operation may be carried out from the PC using the ELDES Conguration software.
NOTE: 0 value disables test period. However, disabling the test period is HIGHLY UNRECOMMENDED.
Unit ID is a 4-digit number (By default – 0000) required to identify the alarm system unit by EGR100 middle-ware. It is RECOMMENDED to
change the default Unit ID before using EGR100.
Set unit ID
EKB2
Menu path:
Server 1: OK → iiii → OK → MS SETTINGS → OK → IP SETTINGS → OK → SERVER IP → OK → UNIT
ID → OK → unid → OK
Server 2: ... → SERVER2 IP → OK → UNIT ID → OK → unid → OK
Server 3: ... → SERVER3 IP → OK → UNIT ID → OK → unid → OK
Value: iiii – 4-digit installer code; unid – 4-digit unit ID number.
EKB3/
EKB3W/
EWKB4
Enter parameter 47 and unit ID number/parameter 96, parameter number and unit
ID number:
Server 1: 47 unid #
Server 2: 96 14 unid #
Server 3: 96 15 unid #
Value: unid – 4-digit unit ID number.
Example: 472245#