Electrovert Bravo 8105 - Miscellaneous Timers Configuration; Timers Parameters

CONFIGURATION SCREENS
Miscellaneous Timers Configuration
9-102 Bravo™ 8105 Programming and Operations Guide Rev. 2
9
Miscellaneous Timers Configuration
Introduction The timers are preset at the factory and should not be changed. If “fine–tuning”
is necessary, it should be performed by qualified Speedline Field Service
Personnel.
Software Screen
Figure 9–9
Timers Parameters Hard Stop Time Delay
Time delay to ensure a Hard Stop condition exists before latching to that
condition.
Soft Stop Time Delay
Time delay to ensure that a Soft Stop condition exists before latching to that
condition.
Warning Alarm Time Delay
Time delay to ensure that a Warning Alarm condition exists before latching to
that condition.