. . . . .
BRAVO™ SYSTEM OPERATION
Configuring Security Access and Passwords
2-9317-372-00-0 Bravo™ 8105 Programming and Operations Guide 4-49
Security Access Screen
Introduction There are three (3) area of security that are configured in the Security
Administration Screen. Additionally, there is a timer parameter that is user–
configured. Refer to the following topics for definitions of the parameters.
Recipe Load
• Allows user to load a recipe into the machine parameters
Modify
• Allows user to modify a recipe that is
Save/Delete
• Allows user to save a recipe or delete a recipe from the machine file
Relative Board Change
• Allows user to reset the Relative Board parameter.
SetUp/Configure Configure Functions
• Allows user to access the Configure Menu. Note that unless Computer Func-
tions is also selected, the first option on the Configure Menu, PC Settings, is
not accessible.
SetUp Functions
• Allows user to access the SetUp Menu.
Calibration Functions
• Allows user to access the Calibration Menu. The Width Sensors and the
Blowers are calibrated through the Calibration Menu.
Motorized Width
• Allows changes to the optional Motorized Width Adjust for the Pin Chain Con-
veyor.
Machine Operation Start/Stop
• Allows user to Start or Stop the Bravo™ System and toggle the Machine Mode
from Manual to Auto.
Maintenance Functions
• Allows user access to the Maintenance and Diagnostics Menu.
Computer Functions
• Allows user access to the PC Settings Window in the Configure Menu.
Change Setpoints/States
• Allows user to change the setpoints to the active recipe in the Process
Screen, as well as turn components On and Off.
To Next Page
Loading...