SAFETY INFORMATION
Perform Required Task
1-16 Bravo™ 8105 Programming and Operations Guide Rev. 2
1
Perform Required Task
Introduction Proceed with the specific maintenance, installation, upgrade, or repair procedures
required. Follow the directions in the Guides supplied with the system.
Safety To ensure personal safety and avoid equipment damage, observe the following:
Electrical Hazard
Electrical current used can kill. DO NOT TOUCH live electrical components inside
the electrical enclosure. These procedures must be performed only by an
authorized electrician, electrical engineer, or service technician familiar with
testing live voltage.
Hot Surface
Components in the system become hot during normal system operation. Heated
sections of the machine produce steam. To prevent burns, allow heated sections
or hot components to cool or wear required safety clothing when accessing
heated areas of the machine for maintenance, installation, upgrade, or repair
procedures.
ATTENTION
If procedures must continue past the shift of the person who applied the lockout
device, ensure that an employee who is working the next shift applies their
lockout device and the previous person removes the initial lockout device.
To Next Page
Loading...