Endress+Hauser Proline Prosonic Flow 93 - Page 132

3 Transducer Blocks (transmission blocks) PROline Prosonic Flow 93 FOUNDATION Fieldbus
132 Endress+Hauser
A = Main line,
B = Additional
line,
C = Information
line
Main Line -
Assign
AUTO - OOS Use this parameter to define the display value assigned to the main
line (the top line of the local display) during normal measuring
operation.
Options:
OFF
VOLUME FLOW CH1
VOLUME FLOW CH2
CALC. VOLUME FLOW
VOLUME FLOW % CH1
VOLUME FLOW % CH2
CALC. VOLUME FLOW %
SOUND VELOCITY CH1
SOUND VELOCITY CH2
SOUND VELOCITY AVG.
SIGNAL STRENGTH CH1
SIGNAL STRENGTH CH2
FLOW VELOCITY CH1
FLOW VELOCITY CH2
FLOW VELOCITY AVG.
TOTALIZER 1
TOTALIZER 2
TOTALIZER 3
AI 1 - OUT VALUE
AI 2 - OUT VALUE
AI 3 - OUT VALUE
AI 4 - OUT VALUE
AI 5 - OUT VALUE
AI 6 - OUT VALUE
AI 7 - OUT VALUE
AI 8 - OUT VALUE
PID - IN VALUE (controlled variable)
PID - CAS IN VALUE (remote setpoint value)
PID - OUT VALUE (manipulated variable)
Factory setting:
VOLUME FLOW CH1
“TRANSDUCER_DISP” (E+H parameters) / base index 1500
Parameter Write access
with operating
mode
(MODE_BLK)
Description
-
+
ENDRESS+HAUSER
E
ESC
A
B
C
F-x3xxxxx-07-05-xx-xx-000