327
On/Standby
light
Status light Lamp light Temp light Status and solution
Off Flashing blue Orange Orange Obstacle detection error. A beep
sounds, and the message "For safety
purposes remove any obstacles
blocking the lens." is displayed. The
projector turns off automatically if no
action is taken.
• Make sure that there are no
obstacles interfering with the
projection window. Remove any
obstacles.
• Clean the obstacle sensor if there
are no obstacles.
If the problem persists, turn the
projector off, unplug it, and contact
Epson for help
Note: If the lights display a pattern not listed in the table above, turn the projector off, unplug it, and
contact Epson for help.
Parent topic: Solving Problems
Related references
Projector Setup Settings - Extended Menu
Using the Projector Help Displays
You can display information to help you solve common problems using the projector's Help system.
1. Turn on the projector.
2. Press the Home button on the projector or the remote control.
3. Press the arrow buttons to select the Help icon and press Enter.
4. Select Display the Help menu.
5. Press Enter.
You see the Help menu.
To Next Page
Loading...
Need help?
General