Epson H6000III - TM Two-color Thermal Line - Page 136

D-2 Comparison Table Rev. E
Thermal print speed
(Receipt)
Single color mode:
max 170 mm/s
2-color print mode:
max 75 mm/s
Single color mode:
max 170 mm/s
2-color print mode:
max 75 mm/s
Single color mode:
max 200 mm/s
2-color print mode:
max 78 mm/s
Single color mode:
max 200 mm/s
2-color print mode:
max 78 mm/s
Optional roll paper spacer
for 58mm or 60mm PG-58
Available by memory switch
setting option: PG-58
Print speed:
Single color mode:
max 150 mm/s
2-color print mode:
max 75 mm/s
Available by memory switch
setting option: PG-58
Print speed:
Single color mode:
max 150 mm/s
2-color print mode:
max 75 mm/s
-- --
Ladder barcode print speed max 114 mm/s max 114 mm/s max 118 mm/s max 118 mm/s
Paper feed speed Approximately 170 mm/s {6.7"/s}
continuous feeding
Approximately 170 mm/s {6.7"/s}
continuous feeding
Approximately 200 mm/s {7.9"/s}
continuous feeding
Approximately 200 mm/s {7.9"/s}
continuous feeding
Slip print speed Approximately 5.14lps Approximately 5.14lps Approximately 5.7lps Approximately 5.7lps
Paper Roll Supply Device
Section Paper roll end
detection
Detection method:
Reflective photo sensor
Detection method:
Reflective photo sensor
Detection method:
Micro switch
Detection method:
Micro switch
Printing and Cutting Positions Manual cutter position:
Approximately 27
Auto cutter position:
Approximately 10.5
Manual cutter position:
Approximately 27
Auto cutter position:
Approximately 10.5
Manual cutter position:
Approximately 24
Auto cutter position:
Approximately 10
Manual cutter position:
Approximately 24
Auto cutter position:
Approximately 10
Dip Switch 2-3, 2-4 If the print density is set to level 3
or 4, printing speed is usually
reduced.
If the print density is set to level 3
or 4, printing speed is usually
reduced.
If the print density is set to level
3 or 4, printing speed is as
below.
max 180mm/s(at24V, 25°C
Print density level3)
max 170mm/s(at24V, 25°C
Print density level4)
If the print density is set to level
3 or 4, printing speed is as
below.
max 180mm/s(at24V, 25°C
Print density level3)
max 170mm/s(at24V, 25°C
Print density level4)
EMI (CE marking) Class A Class A Class A
(Oceania model is Class B)
Class A
(Oceania model is Class B)
OPOS supported version (*2) 2.10E SP4 or later 2.30 SP3 or later 2.50 or later 2.50 or later
Specification related items TM-H6000II
with Image Scanner Model
TM-H6000II Photo-ID Model
with Image Scanner
TM-H6000III
with Image Scanner Model
TM-H6000III Photo-ID Model
with Image Scanner