EasyManuals Logo

Epson H6000III - TM Two-color Thermal Line User Manual

Epson H6000III - TM Two-color Thermal Line
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
1-18 General Information Rev. E
To print endorsements in the specified area (within 38.1 mm {1.5”} from the top), set the
print position for the last line so that it is printed at least 3 mm {0.118”} above the bottom of
the printable area (Especially when the printer is used near the display device, the user is
required to check the recognition rate of the MICR).
NOTE:
1. Do not install the printer near any magnetic fields, because this may cause MICR reading errors. (Be sure to
check the MICR recognition rate when the printer is used near a display device.)
2. MICR characters may not be recognized when impact or vibration is applied to the printer.
Endorsement printing
1.4.4.4 Notes on using the MICR reader
The personal checks must be flat, without curls, folds, or wrinkles (especially at the edges).
Otherwise, the check may rub against the ribbon and become ink-stained.
Do not insert checks that have clips or staples. These may cause paper jams, MICR reading
errors, and damage to the MICR head.
Let go of the check immediately as soon as the printer starts feeding it. Otherwise, the paper
is not fed straight, causing paper jams and MICR reading errors.
Specified printing aria
38.1
[Units : mm (All numeric values are typical.)]

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson H6000III - TM Two-color Thermal Line and is the answer not in the manual?

Epson H6000III - TM Two-color Thermal Line Specifications

General IconGeneral
BrandEpson
ModelH6000III - TM Two-color Thermal Line
CategoryPrinter
LanguageEnglish

Related product manuals