1-6 General Information Rev. E
1.4.1.3 Paper Specifications
NOTE:
Paper must not be pasted to the paper roll spool.
When paper other than that specified is used, the thermal print head may be worn out.Be sure to use the
specified paper.
Depending on each paper specification, it is recommended to set the DIP switch.
(See “When Using Original Paper” on page 3-23.)
Paper type: Specified thermal paper
Form: Paper roll
Paper width: 79.5
± 0.5 mm {3.13" ± 0.02"}
Paper roll size: Roll diameter: Maximum 83 mm {3.27"}
Take-up paper roll width: 80+0.5/-1.0 mm {3.15+0.02/-0.04"}
Specified paper: Specified thermal roll paper, NTP080-80
In Japan: Nakagawa Mfg. Co., Ltd.
In USA: Nakagawa Mfg. (USA) Inc.
In Europe: Nakagawa Mfg. (Europe) GmbH
In Southeast Asia: N.A.K. Mfg. (Malaysia) SDN BHD
[Original paper: TF50KS-E (paper thickness: 65µm) Nippon
Paper Industries Co.,Ltd.]
The following paper can be used instead of the specified paper
above:
Original paper: PD 160R (paper thickness: 75µm) (Oji Paper
Mfg. Co. Ltd.)
Original paper: AF50KS-E (paper thickness: 65µm) (Jujo
Thermal Oy (Finland))
Original paper: P350(F380) (paper thickness: 62µm) (Kanzaki
Specialty Papers, Inc. (U.S.A.))
Original paper: P310 (paper thickness: 58µm) (Kanzaki
Specialty Papers, Inc. (U.S.A.))
Original paper: P300 (paper thickness: 56µm) (Kanzaki
Specialty Papers, Inc. (U.S.A.))
Original paper: F5041 (paper thickness: 60µm) (Mitsubishi
HiTec Paper Flensburg GmbH (Germany))
Specified two-color thermal roll paper, ENTPB080080
In Japan: Nakagawa Mfg. Co., Ltd.
In USA: Nakagawa Mfg. (USA) Inc.
In Europe: Nakagawa Mfg. (Europe) GmbH
In Southeast Asia: N.A.K. Mfg. (Malaysia) SDN BHD
[Original paper: PD750R (paper thickness: 75µm) Oji Paper
Mfg. Co.,Ltd.] Paper roll which is made of the original paper
PD750R can be used.
NOTE: With some printing patterns, the previous print color may not be
cleared. The printer’s reliability when two-color thermal paper is used differs
from the reliability when monochrome paper is used.
Paper roll spool diameter: Inside: 12 mm {.47"} Outside: 18 mm {.71"}