Epson H6000III - TM Two-color Thermal Line User Manual

Rev. E Application Development for Image Scanner 7-1
TM-H6000III Technical Reference Guide
Chapter 7
Application Development for Image Scanner
This section explains key words in a question and answer format and the single-pass processing
for developing a system with the TM-H6000III with the image scanner.
7.1 The flow of single pass processing
The following figures introduce you to “smart pass processing.“ This processing provides you
MICR reading, slip printing (face & endorsement), and scanning a check with one time insertion.
1. When the check is inserted. 2. MICR reading is completed.
3. Pre-scanning has been done.
(This step is required when you scan with bi-tonal data
format only)
4. Print position for the endorsement printing has been
set (based on the bottom edge of the paper). The
area for reverse printing is limited; therefore when
setting the print area, be sure to note that the
endorsement printing cannot be done within 6.9 mm
(typical) from the bottom of the paper.
MICR head
The direction the
paper has been
fed (forward).
MICR head
Image scanner
The direction the
paper has been
fed (forward).
The direction
the paper has
been fed
(forward).
Endorsement
head

Epson H6000III - TM Two-color Thermal Line Specifications

General

Brand	Epson
Model	H6000III - TM Two-color Thermal Line
Category	Printer
Language	English