Epson H6000III - TM Two-color Thermal Line User Manual

Rev. E Setup 3-5
TM-H6000III Technical Reference Guide
ERROR
Off: Normal condition.
Flashing: Error (refer to the following figure).
3.1.3.3 Control Panel Buttons
The control panel has two paper buttons that you may have to use, although most paper
handling functions will be handled by your software.
FEED
Use this button to feed roll paper or to start a roll paper self test. (See the instructions later in this
chapter.)
RELEASE
Use this button to release slip paper or to start a slip paper self test. (See the instructions later in
this chapter.)
Panel Button Operations
ESC/POS command can be set to enable or disable the panel buttons.
3.1.4 Validation paper handling (Option)
1. Transmit the command from host PC to make the printer ready for a validation paper to
be inserted.
2. Insert a validation paper into the validation entrance from the upper side.
Note:
Use only validation paper (flat paper, without wrinkles, creases, or folds) that matches the
specifications.The validation function is a factory option.
State
SLIP LED Blinking Pattern
Card Ejection error
320 ms
5120 ms
insert the paper against the corner
incorrect insertion correct insertion

Epson H6000III - TM Two-color Thermal Line Specifications

General

Brand	Epson
Model	H6000III - TM Two-color Thermal Line
Category	Printer
Language	English