EasyManuals Logo

Epson H6000III - TM Two-color Thermal Line User Manual

Epson H6000III - TM Two-color Thermal Line
140 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #66 background imageLoading...
Page #66 background image
3-4 Setup Rev. E
SLIP
This light blinks when the printer is ready to receive slip paper. It stays on during printing
on slip paper and blinks again when slip paper should be removed. When the slip paper is
removed in the slip removal waiting state, the printer enters the paper roll mode two
seconds later. The SLIP LED light is on during this time. The blinking patterns for the slip
inserting and removal waiting states are different as follows:
3.1.3.2 LEDs on the Card panel
ID
On: Card scanner is operating.
Off: Card scanner is not selected.
Flashing: Card insertion / removal waiting state (refer to the following table).
State
SLIP LED Blinking Pattern
Slip insertion waiting
Slip removal waiting
Check insertion waiting
(only for MICR-equipped model)
State
SLIP LED Blinking Pattern
Card insertion waiting
Card removal waiting
320 ms
2080 ms
1760 ms
160 ms
2080 ms

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Epson H6000III - TM Two-color Thermal Line and is the answer not in the manual?

Epson H6000III - TM Two-color Thermal Line Specifications

General IconGeneral
BrandEpson
ModelH6000III - TM Two-color Thermal Line
CategoryPrinter
LanguageEnglish

Related product manuals