Rev. E Setup 3-7
TM-H6000III Technical Reference Guide
3.2 Setup Flow
You have to set up your printer to use it. And you can adjust some feature by customizing them.
This section describes the setup.
The set up flow of preparing to use printer is below..
Note:
When you use OPOS (OCX driver from EPSON), Advanced Printer Driver, or JavaPOS, you need to
install the driver. When you use ESC/POS commands, you don’t have to install drivers. For information
on these drivers, see “Control Method” (page 2-1).
Driver setup
❏ APD
❏ OPOS
❏ OPOS for .NET
❏ JavaPOS
Complete set up
Printer setup (See “Printer setup,” page 3-8)
Printer customizing (See “Customizing,” page 3-18)
To Next Page
Loading...
