Epson H6000III - TM Two-color Thermal Line User Manual

Rev. E Setup 3-19
TM-H6000III Technical Reference Guide
3.4.3 Adjusting the DIP Switches
The printer has two sets of DIP switches. The function of the DIP switches is different for each
interface model.
3.4.3.1 Changing the DIP Switch Settings
If you need to change settings, follow the steps below to make your changes:
CAUTION:
Turn off the power while removing the DIP switch cover to prevent an electric short,
which can damage the printer.
Use a crosshead screwdriver to remove the screw holding the DIP switch cover.
1. Make sure the printer is turned off.
2. Remove the screw from the DIP switch cover. Then take off the DIP switch cover.
3. Set switches using a pointed tool, such as tweezers or a small screwdriver.
4. Replace the DIP switch cover. Then secure it with the screw.
The new settings take effect when you turn on the printer.
Note:
The functions of the switches of are shown in the following sections.
DIP switch cover
switches

Epson H6000III - TM Two-color Thermal Line Specifications

General

Brand	Epson
Model	H6000III - TM Two-color Thermal Line
Category	Printer
Language	English