2-10 System Planning Rev. E
Connection procedure
CAUTION:
Connecting devices directly to LAN cables that are installed outdoors will expose them
to damage from power surges caused by lightning and other inductive sources. It is best
to make sure that devices without proper surge protection are cushioned by being
connected through devices that do have surge protection. Otherwise, it is better not to
connect them to outdoor lines.
Never attempt to connect the Customer Display cable, drawer kick out cable or the
standard telephone line cable to the 10 Base-T Ethernet connector.
1. Confirm that the power supplies for both the printer and the host computer have been
turned off.
2. Connect the 10 Base-T cable to the 10 Base-T Ethernet connector by pressing firmly until the
connectors click.
Note:
For the various methods of setting the Ethernet interface, refer to the Technical Reference Guide for the
interface. It is downloadable from the web site. See “Downloading Drivers, Utilities, and Manuals” on
page 2-4.
To Next Page
Loading...
Need help?
General