Epson RC700 Series User Manual

Maintenance 9. Troubleshooting
RC700 / RC700-A Rev.23 301
9.2.2 When recognized under “Other devices” in Windows Device
Manager
If “EPSON Robot Controller RC170” is recognized under “Other devices” in the Windows
device manager as shown in the following dialog, delete “EPSON Robot Controller
RC170” from the device manager and connect the USB cable again to correct the problem.
(1) Select and right click “EPSON Robot Controller RC170” in the [Device Manager]
dialog.
(2) Select [Uninstall].
(3) The [Confirm Device Removal] dialog appears.
Click the <OK> button.
(4) Remove the USB cable and connect the USB cable again. The following message
appears at the right bottom of the Windows screen.
(5) When the Controller is installed automatically and the following message appears, the
communication is available.
If the problem is not corrected, please contact the supplier of your region.

NOTE

Epson RC700 Series Specifications

General

Model	RC700 series
Category	Controller
Programming Language	SPEL+
Safety Standard	ISO 10218-1
Type	Robot Controller
Communication Interface	Ethernet, RS-232, USB
Operating Temperature	0°C to 45°C (32°F to 113°F)
Humidity	20% to 80% (non-condensing)
Number of controllable robots	4