EasyManua.ls Logo

Epson RC700 Series - Board Settings (EUROMAP67 Board); Installation (EUROMAP67 Board)

Epson RC700 Series
316 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Setup & Operation 14. Option Slots
108 RC700 / RC700-A Rev.23
14.8.2 Board Settings (EUROMAP67 Board)
Configure DIP-Switch (SW1) to enable the robot controller to recognize the
EUROMAP67 board.
Board Appearance
Switch setting: Setup the DSW1
SW1
1
st
board
2
nd
board
14.8.3 Installation (EUROMAP67 Board)
(1) Turn OFF the Controller.
(2) Disconnect the power plug.
(3) Remove the Top Panel. (Mounting screw ×6)
(4) Insert the EUROMAP67 board into either slots 1, 2 or 3.
(Slot 4 cannot be used.)
(5) Use four screws to fix the EUROMAP67 board in place.
First, temporarily fasten the four screws in place. Next, fully tighten screws located
diagonally opposite each other.
Take care not to damage the thread holes when doing so.

Table of Contents

Other manuals for Epson RC700 Series

Related product manuals