Epson RC700 Series - Program Mode (AUTO); What Is Program Mode (AUTO); Setup from EPSON RC

Safety 4. Operation Mode (TEACH/AUTO/TEST)
RC700 / RC700-A Rev.23 37
4.3 Program Mode (AUTO)
4.3.1 What is Program Mode (AUTO)?
Program mode is for programming, debug, adjustment, and maintenance of the Robot
system.
Follow the procedures below to switch to the Program mode.
4.3.2 Setup from EPSON RC+
Switch the mode to Program mode from the EPSON RC+.
(1) Select EPSON RC+ menu-[Setup]-[System Configuration] to display the [System
Configuration] dialog.
(2)
(5)
(3)
(4)
(2) Select [Startup]-[Start mode].
(3) Select <Program> button.
(4) Click the <Apply> button.
(5) Click the <Close> button.