Epson RC700 Series User Manual

Safety 3. Installation
RC700 / RC700-A Rev.23 29
3.3.2 AC Power Cable
WARNING

Make sure that operations are done by a qualified personal.

Be sure to connect the earth wire (green/yellow) of the AC power cable to
the
earth terminal of the factory power supply. The equipment must be grounded
properly at all times to avoid the risk of electric shock.

Always use a power plug or a disconnecting device
for power connecting cable.
Never connect the Controller directly to the factory power supply.

Select the plug or a
disconnecting device which conform safety standards for
nations.
Make sure to insert the plug of the AC power cable firmly when connecting to the
Controller.
Item Specification
AC power wire (2 cables)
Black, Black
or Black, White
Ground wire Green / Yellow
Cable length 3 m
Terminal
M4 round solderless terminal

Epson RC700 Series Specifications

General

Model	RC700 series
Category	Controller
Programming Language	SPEL+
Safety Standard	ISO 10218-1
Type	Robot Controller
Communication Interface	Ethernet, RS-232, USB
Operating Temperature	0°C to 45°C (32°F to 113°F)
Humidity	20% to 80% (non-condensing)
Number of controllable robots	4