Epson RC700 Series User Manual

Setup & Operation 14. Option Slots
RC700 / RC700-A Rev.23 109
(6) Connect “Cable1 CN2”.
Use a cross-point screwdriver to fasten the connector (CN2).
(7) Refer to the following to connect CN3 to the emergency stop switch (emergency stop,
safety door, latch).
Setup & Operation 9. EMERGENCY
(8) Connect “CN3”.
Use a cross-point screwdriver to fasten the connector (CN3).

Epson RC700 Series Specifications

General

Model	RC700 series
Category	Controller
Programming Language	SPEL+
Safety Standard	ISO 10218-1
Type	Robot Controller
Communication Interface	Ethernet, RS-232, USB
Operating Temperature	0°C to 45°C (32°F to 113°F)
Humidity	20% to 80% (non-condensing)
Number of controllable robots	4