Epson Stylus Pro GS6000 - Page 107

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 107
Confidential
7. Remove the two screws and remove the fixing plate.
B) Silver, Phillips, Pan with S.W & P.W M3x30: two pieces
Figure 4-54. Removing the fixing plate
4.4.5.5 COOLING FAN PE
1. Remove the five screws and open the Elec Box. See Figure 4-40.
A) Silver, Phillips, Pan with S.W & P.W M4x8: five pieces
2. Disconnect the relay connector, and release the harness from the two clamps.
3. Remove the two screws that secure the fixing plate to the main unit.
A) Silver, Phillips, Pan with S.W & P.W M4x6: two pieces
Figure 4-55. Removing the COOLING FAN PE from the main unit
When routing the cable, make sure to give it one turn around the
marked clamp. See Figure 4-53.
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p184) and perform
specified adjustments after replacing or removing this part.
<Adjustment item>
1. Fan Test
B
HEATER BOARD
COOLING FAN
Fixing plate
Fixing plate
Relay connector
Clamps
Screws A