Epson Stylus Pro GS6000 - Page 106

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 106
Confidential
12. Move the Carriage to the platen and release the cable from the three clamps.
13. Remove the four screws and remove the fan and the fan guard.
A) Silver, Phillips, Pan with S.W & P.W M3x20: four pieces
Figure 4-52. Removing the COOLING FAN
4.4.5.4 HEATER BOARD COOLING FAN
The ASP part name is “COOLING FAN”.
1. Remove the MAINTENANCE COVER ASSY (both). (p91)
2. Remove the MAINTE COVER, B (both). (p92)
3. Remove the PAPER GUIDE COVER (both). (p94)
4. Remove the After Heater Cover. (p97)
5. Disconnect the cable from connector J10 on the HEATER RELAY BOARD
ASSY, and release it from the clamp.
6. Remove the two screws and remove the fan with its fixing plate.
A) Silver, Phillips, Pan with S.W & P.W M4x6: two pieces
Figure 4-53. Detaching the HEATER BOARD COOLING FAN
 When routing the cable, make sure to give it one turn around
the marked clamp. See Figure 4-52.
 When installing the fan, make sure to set the side with a label to
the platen (downward).
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p184) and perform
specified adjustments after replacing or removing this part.
<Adjustment item>
1. Fan Test
A
Clamp to turn
Clamp
Clamp
Fan cable
As seen from
the front
A
Inside the After Heater Cover
HEATER BOARD
COOLING FAN
Clamp to turn
Fan cable
Fixing plate