Epson Stylus Pro GS6000 - Page 105

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 105
Confidential
8. Move the Carriage back to the left end and remove the four screws on the sides.
A) Silver, Phillips, Cup M3x6: four pieces
Figure 4-49. Removing the screws (sides)
9. Remove the two screws from the rear and remove the CR Top Cover (not an ASP).
A) Silver, Phillips, Cup M3x6: two pieces
Figure 4-50. Removing the screws (rear)
10. Disconnect the FFCs in front from the SUB-A BOARD ASSY as shown in the
figure below.
11. Disconnect the relay connector (on top) and release the cable from the clamp (on
top).
Figure 4-51. Disconnecting the cables
A
As seen from the top
Carriage Top Cover
A
As seen from the rear
Carriage Top Cover
SUB_A BOARD ASSY
As seen from the top
Relay connector
Clamp
FFCs to disconnect