Epson Stylus Pro GS6000 - Page 104

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 104
Confidential
4.4.5.3 COOLING FAN
1. Remove the TOP COVER (left only). (p85)
2. Remove the MAINTE COVER T. (p86)
3. Remove the SIDE COVER (left only). (p89)
4. Remove the IH COVER (left only). (p90)
5. Unlock the Carriage. (p83)
6. Move the Carriage to the left end and remove the four screws.
A) Silver, Phillips, Cup M3x6: four pieces
7. Move the Carriage to the Platen and remove the Carriage Cover (not an ASP).
Figure 4-48. Removing the screws of Carriage Cover
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p184) and perform
specified adjustments after replacing or removing this part.
<Adjustment item>
1. Fan Test
C H E C K
P O I N T
Basically you can remove this part on the left and the one on the
right in the same way. Therefore this section (from Step 9 and
later) describes the way to remove the one on the right only.
A
As seen from the top
Carriage Cover
A
Carriage Cover
As seen from the front