Epson Stylus Pro GS6000 - Page 103

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 103
Confidential
4.4.5.2 VACUUM FAN
1. Remove the 16 screws and 16 washers.
A) Screws; special flat head screw: 16 pieces
Washers; wave washer: 16 pieces
2. Open the Platen from the front.
3. Disconnect the six connectors and remove the Platen.
Figure 4-46. Removing the Platen
4. Remove the two screws and disconnect the connector, then remove the VACUUM
FAN.
A) Silver, Phillips, Pan with S.W & P.W M4x10: two pieces
Figure 4-47. Removing the VACUUM FAN
C A U T I O N
When removing the Platen, take care not to lose the washers.
Inside the Platen
Connector
A
Platen
When reassembling the Platen, take care not to catch the cables
between the Platen and the fixing plates. See Figure 4-47.
C A U T I O N
In the next step, do not touch any screws adjusting the platen
(marked with yellow circles in the figure below), or the printer may
not print normally. The screws keep the factory-adjusted
Parallelism.
Inside the Platen
VACUUM FAN
A
Inside the Platen
VACUUM FAN
Connector
Fixing plate