Epson Stylus Pro GS6000 - Page 115

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 115
Confidential
Figure 4-67. Connector Layout of the HEATER RELAY BOARD ASSY
Connector assignment:
Connector No. Color Destination
J1
White Relay
J2
White PLATEN HEATER
J3
Black HEATER CONT BOARD ASSY (J6)
J4*
White Unused
J5
White PLATEN HEATER
J6
White Relay
J7
White PRE HEATER
J8
White PRE HEATER
J9
White AFTER HEATER
J10
Blue Heater Board Cooling Fan
J11
White COOLING FAN (24V)
J12
White THERMISTOR, PLATEN
J13
Black THERMISTOR, PLATEN
J14
Black COOLING FAN (24V)
J15
Red THERMISTOR, PRE
J10 J11 J14 J12 J15 J17 J19*
J3
J9
J13 J16 J18 J20*
J6 J7 J8 J5 J1 J2
J4*
*: Unused
J16
Yellow THERMISTOR, PRE
J17
White THERMISTOR, AFTER
J18
Black THERMISTOR, AFTER
J19*
Red Unused
J20*
Yellow Unused
 Some connectors are not used for this printer. Make sure not to
confuse them with the correct ones when reassembling.
 When connecting the cables, use the markings on them to
distinguish them apart.
 When connecting the cables, route them correctly referring to
the figure below.
Connector No. Color Destination
HEATER CONT
BOARD ASSY
HEATER RELAY
BOARD ASSY
J1J6
J23
J19
J8
Relay