Epson Stylus Pro GS6000 - Page 114

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 114
Confidential
4.4.6.5 HEATER RELAY BOARD ASSY
1. Remove the MAINTENANCE COVER ASSY (both). (p91)
2. Remove the MAINTE COVER, B (both). (p92)
3. Remove the PAPER GUIDE COVER (both). (p94)
4. Remove the After Heater Cover. (p97)
5. Disconnect all the connectors.
6. Remove the six screws and remove the HEATER RELAY BOARD ASSY.
A) Silver, Phillips, Cup M3x6: six pieces
Figure 4-66. Removing the HEATER RELAY BOARD ASSY
 Some connectors are not used for this printer. Make sure not to
confuse them with the correct ones when reassembling.
 When connecting the cables, use the markings on them to
distinguish them apart such as the ones shown below.
 When connecting the cables, route them correctly referring to
the figure below.
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p184) and perform
specified adjustments after replacing or removing this part.
<Adjustment item>
1. F/W Update
J
M
HEATER CONT BOARD ASSY
Cables
J9
J10
HEATER CONT
BOARD ASSY
HEATER RELAY
BOARD ASSY
J1J6
J23
J19
J8
Relay
A
HEATER RELAY BOARD ASSY
Inside the After Heater Cover