Epson Stylus Pro GS6000 - Page 113

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 113
Confidential
4.4.6.4 HEATER CONT BOARD ASSY
1. Remove the MAINTENANCE COVER ASSY (both). (p91)
2. Remove the MAINTE COVER, B (both). (p92)
3. Remove the PAPER GUIDE COVER (both). (p94)
4. Remove the After Heater Cover. (p97)
5. Disconnect all the connectors.
6. Remove the four screws and remove the HEATER CONT BOARD ASSY.
A) Silver, Phillips, Cup M3x6: four pieces
Figure 4-64. Removing the HEATER CONT BOARD ASSY
Figure 4-65. Connector Layout of the HEATER CONT BOARD ASSY
Connector assignment:
HEATER CONT BOARD ASSY
A
Inside the After Heater Cover
Relay
Connector No. Color Destination
J1*
Black Unused
J6
(FFC) HEATER RELAY BOARD ASSY (J3)
J8
White Relay
J9
Gray SUB_B BOARD ASSY (J17)
J10
Gray LVDS BOARD (J2)
J11*
White Unused
J19
White Relay
J22
White TERMINAL BLOCK
J23
White HEATER RELAY BOARD ASSY (J1)
J1*
J10
J9
J8
J19
J6
J23
J22
J11*
*: Unused