Epson Stylus Pro GS6000 - Page 112

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 112
Confidential
CN20
(FFC) SUB_A BOARD ASSY (J1)
CN21
(FFC) SUB_A BOARD ASSY (J2)
CN22
(FFC) SUB_A BOARD ASSY (J3)
CN23
(FFC) SUB_B BOARD ASSY (J1)
CN24
(FFC) SUB_C BOARD ASSY (J1)
CN25
(FFC) SUB_D BOARD ASSY (J1)
CN26
(FFC) SUB_D BOARD ASSY (J1)
CN28
Red VACUUM FAN
CN29
Yellow VACUUM FAN
CN30
Black VACUUM FAN
CN31
Blue VACUUM FAN
CN34
Black CR LOCK SOLENOID
CN35
White HEATER BOARD COOLING FAN
CN38*
Black Unused
CN39*
Red Unused
CN40*
Yellow Unused
CN41*
Blue Unused
CN48
(FFC) ALARM LED (CN1)
CN64
White SUB_C BOARD ASSY (J4)
CN65
Black SUB_B BOARD ASSY (J8)
CN66*
Yellow Unused
CN501
--- LAN
CN506
White C679PROG
CN507
(FFC) LVDS BOARD (J1)
CN508*
Beige Unused
CN509
White COOLING FAN PE
Connector No. Color Destination
Some connectors are not used for this printer. Make sure not to
confuse them with the correct ones when reassembling.
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p184) and perform
specified adjustments after replacing the MAIN BOARD ASSY.
<Adjustment items>
 NVRAM Backup OK
1. NVRAM Backup
2. F/W Update
3. NVRAM Restore
 NVRAM Backup NG
1. F/W Update
2. NVRAM CLEAR OK
3. CR Origin Adjustment
4. Rear Sensor Test/Rear AD Adjustment
5. Washing Sequence ON/OFF Flag
6. Initial Ink Flag
7. Input Serial Number
8. Head Rank Input
9. RTC and USB ID
10. Nozzle Check Pattern
11. Cleaning and Washing
12. Head Uni-D/Bi-D Low Gap Adjustment
13. Paper Feed Adjustment
14. Media Side Margin Adjustment
15. IP Address Setup & Network Test