Epson Stylus Pro GS6000 - Page 119

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 119
Confidential
4.4.6.9 SUB_B BOARD ASSY
1. Remove the REAR PAPER GUIDE. (p96)
2. Remove the SPINDLE GUIDE COVER. (p97)
3. Disconnect all the cables and FFCs from the SUB_B BOARD ASSY.
4. Remove the six screws, and remove the SUB_B BOARD ASSY.
A) Silver, Phillips, Cup M3x6: six pieces
Figure 4-76. Removing the SUB_B BOARD ASSY
J5
(FFC) PRINT HEAD
J6
(FFC) PRINT HEAD
J7
(FFC) PRINT HEAD
J8
(FFC) PRINT HEAD
J9
(FFC) PRINT HEAD
J10
(FFC) PRINT HEAD
J11
(FFC) PRINT HEAD
J12*
White Unused
J13
Black COOLING FAN
J14
Red COOLING FAN
J15
White CR ENCODER ASSY
J16
Black PAPER EDGE SENSOR
J17
White PG HEIGHT SENSOR
J18*
Brown Unused
J19*
White Unused
Some connectors are not used for this printer. Make sure not to
confuse them with the correct ones when reassembling.
Connector No. Color Destination
C A U T I O N
So as not to confuse J17 and J18 connectors of serial cables, it is
recommended to mark them in some way before disconnecting
them. See Figure 4-76.
A
Inside the REAR PAPER GUIDE
SUB_B BOARD ASSY
Serial cables