Epson Stylus Pro GS6000 - Page 118

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 118
Confidential
4.4.6.8 SUB_A BOARD ASSY
1. Remove the TOP COVER (left only). (p85)
2. Remove the MAINTE COVER T. (p86)
3. Remove the SIDE COVER (left only). (p89)
4. Remove the IH COVER (left only). (p90)
5. Unlock the Carriage. (p83)
6. Remove the CR Top Cover (Step 6 to 9 in 4.4.5.3 COOLING FAN). (p104)
7. Disconnect all the cables and FFCs from the SUB_A BOARD ASSY.
Figure 4-73. Disconnecting the cables on the SUB_A BOARD ASSY
8. Remove the five screws, and remove the SUB_A BOARD ASSY.
A) Silver, Phillips, Cup M3x6: five pieces
Figure 4-74. Removing the SUB_A BOARD ASSY
Figure 4-75. Connector Layout of the SUB_A BOARD ASSY
Connector assignment:
SUB_A BOARD ASSY
Carriage
As seen from the top
Connector No. Color Destination
J1
(FFC) MAIN BOARD ASSY (CN20)
J2
(FFC) MAIN BOARD ASSY (CN21)
J3
(FFC) MAIN BOARD ASSY (CN22)
J4
(FFC) PRINT HEAD
A
SUB_A BOARD ASSY
J3 J2 J1
J19*
J8
J9
J10
J11J13J14
J12*
J15
J16
J18* J17 J7
J4
J5
J6
*: Unused