Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 122
Confidential
4.4.6.11 SUB_D BOARD ASSY
1. Remove the TOP COVER. (p85)
2. Remove the PANEL COVER, T. (p86)
3. Remove the SIDE COVER. (p89)
4. Remove the IH COVER. (p90)
5. Disconnect all the cables and FFCs from the SUB_D BOARD ASSY.
6. Remove the four screws, and remove the SUB_D BOARD ASSY.
A) Silver, Phillips, Cup M3x6: four pieces
Figure 4-80. Removing the SUB_D BOARD ASSY (right)
Figure 4-81. Connector Layout of the SUB_D BOARD ASSY
Connector assignment:
Basically you can remove this part on the left and the one on
the right in the same way. Therefore this section describes the
way to remove the one on the right only.
When removing the covers on the left, remove the MAINTE
COVER T (p88) in Step 2.
When removing the IH COVER on the left, remove six screws
only. See Figure 4-25.
A
SUB_D BOARD ASSY
As seen from the top
Alarm LED cable
Connector No. Color Destination
J1
Black MAIN BOARD ASSY (CN25 or CN26)
J2
Black Ink Cartridge (CSIC)
J3
Black Ink Cartridge (CSIC)
J4
Black Ink Cartridge (CSIC)
J5
Black Ink Cartridge (CSIC)
J6*
White Unused
J7
White ALARM LED (right only)
Some connectors are not used for this printer. Make sure not to
confuse them with the correct ones when reassembling.
To Next Page
Loading...
