Epson Stylus Pro GS6000 - Page 125

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 125
Confidential
4.4.7.2 PAPER REAR SENSOR
1. Remove the REAR PAPER GUIDE. (p96)
2. Remove the SPINDLE GUIDE COVER. (p97)
3. Disconnect the cable from connector J6 on the SUB_B BOARD ASSY.
4. Release the cable from three clamps.
Figure 4-84. Releasing the cable
5. Remove the screw, and remove the PAPER REAR SENSOR with its fixing plate.
A) Silver, Phillips, Pan with S.W & P.W M3x8: one piece
6. Remove the two screws, and remove the PAPER REAR SENSOR from the fixing
plate.
B) Silver, Phillips, Cup M2x5: two pieces
Figure 4-85. Removing the PAPER REAR SENSOR
When routing the cable, make sure to give it one turn around the
marked clamp. See Figure 4-84.
J6
Clamps
PAPER REAR SENSOR
Clamp to turn
As seen from the rear
SUB_B BOARD ASSY
B
A
Fixing
plate
PAPER REAR SENSOR
As seen from the rear