Epson Stylus Pro GS6000 - Page 146

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 146
Confidential
8. Detach the scale from the hook and remove it.
Figure 4-113. Removing the CR ENC SCALE
Hook
CR ENC SCALE
As seen from the front
When installing the CR ENC SCALE, pay attention to the
following instructions.
• Set the chipped part of the Scale facing upward.
• Pass the scale through the slit of the CR ENC ASSY.
• When attaching each fixing plate from the right to left (as
seen from the front), first insert the hook in the hole of the
scale, and screw it while pressing the plate to the left.
CR ENC SCALE
Chipped part
As seen from the front
CR ENC SCALE
CR ENC ASSY
Slit
CR ENC SCALE
As seen from the front
Fixing plate
Hook and hole
Screw
Press it left
when screwing