EPSON Stylus Pro GS6000 Revision F
PRODUCT DESCRIPTION Control Panel 25
Confidential
PRINTER SETUP
AUTO TAKE-UP REEL
ON* Use this setting when using the Auto Take-Up Reel Unit. When ON is selected, you cannot feed the roll paper in
the reverse direction.
When the Auto Take-Up Reel Unit is not installed, do not set to ON. By doing so, the product will be
unable to function properly.
OFF
HEAD FAN (COOLING FAN)
ON*
You can set up the head fan operation. If print blurring or dot losses occur, select ON.
OFF
REGULAR CLEANING
OFF You can set the auto cleaning interval of this printer. When more than the set time has passed since the previous
print job, the print head is cleaned automatically to prevent it from clogging.
The timer will be reset at the following timing:
when turning on the printer
when changing the interval of the auto cleaning
when performing the cleaning manually
1h, 2h, 3h, 4h, 5h, 6h*,
9h, 12h, 18h, 24h
ROLL PAPER COUNTER
OFF* In this setting, the alert can be set off when the remaining paper falls below 2m. Enter the remaining amount
(length) of paper currently set on the printer. This menu is displayed only when the REMAINING PPR SETUP
in Maintenance Mode is set to ON.
5 - 99.5m (15 - 300ft)
INITIALIZE SETTINGS EXECUTE You can return all setting values you have made in the Printer Setup menu to their factory set value.
PAPER SETUP
PAPER TYPE
STANDARD*
You can select the paper type to print.
PAPER No.1 - 30
PAPER SETUP
STANDARD* When you select STANDARD, the default settings are used.
When you select a number (between 1 to 30), you can register the settings (such as Print Mode, Paper Feed
Adjust, Head Alignment, Pre Heater, Platen Heater, After Heater, M/W Adjustment, Paper Suction, Drying
Time, Carriage Movement, Print Multiple Layer) or to recall these settings you have made. The number you
select here is displayed on the LCD panel.
See ?Details of PAPER SETUP? (p29).
PAPER No.1 - 30
Menu Item
Parameter
(*: Default setting)
Explanation
To Next Page
Loading...
