Epson Stylus Pro GS6000 - Page 36

Epson Stylus Pro GS6000 Revision F
PRODUCT DESCRIPTION Control Panel 36
Confidential
Test
Ctrl.Test Ctrl.Actuator
Tank Valve
Valve1 On
Operates the solenoids of the sub tank valves.
Valve2 On
Valve3 On
Valve4 On
Valve5 On
Valve6 On
Valve7 On
Valve8 On
Ink Valve
Valve1 On
Operates the solenoids of the ink valves.
Valve2 On
Valve3 On
Valve4 On
Ink Pump Rotates the pump motors.
Wiper Operates the wiper (head cleaner).
Error History
Error0
Displays the error history in reverse chronological order.
Error1
Error2
Error3
Error4
Error5
Edge Sns Lvl Adjusts the media side detection sensor.
Adjustment
CR Origin Adjust Adjusts the CR HP sensor position.
Platen Adjust Used in the factory to warm the platen in a way to do a precise horizontal adjustment.
Heater Temp
Pre Heater Temp
Sets the temperature of the heaters.
(The settings are cancelled when exiting the Serviceman Mode)
Platen Heater Temp
After Heater Temp
Rear AD Adjusts AD value of the paper rear sensor.
Init.Fill Executes the initial ink charge.
Nozzle Check Output Pattern Prints the nozzle check pattern.
Table 1-1. Menu List
Menu Explanation