Epson Stylus Pro GS6000 - Page 86

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 86
Confidential
4.4.3.2 PANEL COVER, T/ALARM LED ASSY/PANEL ASSY
1. Remove the TOP COVER (right only). (p85)
2. Push and open the MAINTENANCE COVER ASSY (right only). See Figure
4-26.
3. Remove the five screws.
A) Silver, Phillips, Pan with S.W & P.W M4x8: five pieces
4. Pull the left side of the PANEL COVER, T slightly and slide the cover up to the
rear.
Figure 4-16. Detaching the PANEL COVER
5. Disconnect the FFC and the cable from their connectors and remove the PANEL
COVER, T.
Figure 4-17. Disconnecting the FFC and the cable
C A U T I O N
In the next step, do not pull away the PANEL COVER, T too far,
because cables are connected to it.
PANEL COVER, T
A
When attaching the PANEL COVER, T, make sure to insert the rib
on the right under the Side Cover (right).
PANEL COVER, T
FFC
Cable
Connectors
Backside
PANEL COVER, T
Rib
SIDE COVER (right)