Epson Stylus Pro GS6000 - Page 87

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 87
Confidential
 ALARM LED
1. Remove the two screws and remove the ALARM LED.
A) Silver, Phillips, Cup M3x6: two pieces
Figure 4-18. Removing the ALARM LED
 PANEL ASSY/PANEL COVER, T
1. Disengage the three springs from the PANEL COVER, T, and remove the PANEL
ASSY.
Figure 4-19. Removing the PANEL ASSY/PANEL COVER, T
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p184) and perform
specified adjustments after replacing or removing this part.
<Adjustment item>
1. Alarm LED Test
ALARM LED
Backside
PANEL COVER, T
A
A D J U S T M E N T
R E Q U I R E D
Be sure to refer to Chapter 5 “Adjustment” (see p184) and perform
specified adjustments after replacing or removing this part.
<Adjustment item>
1. Panel Test
PANEL ASSY
Backside
Springs
PANEL COVER, T