Epson Stylus Pro GS6000 - Page 90

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 90
Confidential
4.4.3.5 IH COVER
1. Remove the TOP COVER. (p85)
2. Remove the PANEL COVER, T. (p86)
3. Remove the SIDE COVER. (p89)
4. Open the Ink Cover (not an ASP).
Figure 4-23. Opening the Ink Cover
5. Remove the three screws from outside.
A) Silver, Phillips, Pan with S.W & P.W M4x8: three pieces
Figure 4-24. Removing the IH COVER (outside)
C H E C K
P O I N T
 Basically you can remove this part on the left and the one on
the right in the same way. Therefore this section describes the
way to remove the one on the right only.
 When removing the covers on the left, remove the MAINTE
COVER T (p88) in Step 2.
Push here
IH COVER
Ink Cover
As seen from the rear
IH COVER
A
As seen from the outside