Epson Stylus Pro GS6000 - Printer Specifications: Printing and Ink

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 89
Confidential
4.4.3.4 SIDE COVER
1. Remove the TOP COVER. (p85)
2. Remove the PANEL COVER, T. (p86)
3. Remove the eight screws and remove the SIDE COVER.
A) Silver, Phillips, Pan with S.W & P.W M4x8: seven pieces
B) Silver, Phillips, Bind P-tite M4x10: one piece
Figure 4-21. Removing the SIDE COVER (top)
Figure 4-22. Removing the SIDE COVER (bottom)
C H E C K
P O I N T
 Basically you can remove this part on the left and the one on
the right in the same way. Therefore this section describes the
way to remove the one on the right only.
 When removing the covers on the left, remove the MAINTE
COVER T (p88) in Step 2.
SIDE COVER (right)
B
A
As seen from the top
Be careful not to fasten the B screw too strong as the cover material
is quite soft and it would enlarge the screw hole, hence decreasing
the fastening efficiency. See Figure 4-21.
A
SIDE COVER (right)
As seen from the bottom