Epson Stylus Pro GS6000 - Page 92

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 92
Confidential
4.4.3.7 MAINTE COVER, B
1. Remove the MAINTENANCE COVER ASSY. (p91)
2. Remove the two screws.
A) Silver, Phillips, Pan with S.W & P.W M4x8: two pieces
3. Lift the MAINTE COVER, B and remove it.
Figure 4-27. Removing the MAINTE COVER, B
4.4.3.8 SIDE COVER, L2
1. Remove the TOP COVER (left only). (p85)
2. Remove the MAINTE COVER T. (p86)
3. Remove the SIDE COVER (left only). (p89)
4. Remove the three screws and remove the SIDE COVER, L2.
A) Silver, Phillips, Pan with S.W & P.W M4x8: three pieces
Figure 4-28. Removing the SIDE COVER, L2
C H E C K
P O I N T
Basically you can remove this part on the left and the one on the
right in the same way. Therefore this section describes the way to
remove the one on the right only.
MAINTE COVER, B
A
Front Right
SIDE COVER, L2
A
As seen from the bottom