Epson Stylus Pro GS6000 - Page 93

Epson Stylus Pro GS6000 Revision F
DISASSEMBLY & ASSEMBLY Disassembly and Assembly Procedure 93
Confidential
4.4.3.9 PRESSURE LEVER COVER
1. Remove the TOP COVER (right only). (p85)
2. Remove the PANEL COVER, T. (p86)
3. Remove the SIDE COVER (right only). (p89)
4. Remove the IH COVER (right only). (p90)
5. While pushing the knob up, remove the screw and remove the knob.
A) Silver, Phillips, Pan with S.W & P.W M3x6: one piece
Figure 4-29. Removing the Knob
6. Remove the two screws and remove the PRESSURE LEVER COVER.
A) Silver, Phillips, Pan with S.W & P.W M4x8: one piece
B) Silver, Phillips, Bind P-tite M3x8: one piece
Figure 4-30. Removing the PRESSURE LEVER COVER
Knob
A
Right inside
Push up
C H E C K
P O I N T
To make it easier to remove the screw of the PRESSURE LEVER
COVER from the rear, it is recommended to use a screwdriver
with more than 25 cm long shaft.
PRESSURE LEVER
COVER
B
A
As seen from the rear